Brake Light Pulser - Plug-in (10-14 All)

Brake Light Pulser - Plug-in (10-14 All)
Click to Enlarge

TRANSCRIPT

Hi, I'm Justin with AmericanMuscle.com, and I have with me a simple plug-n-play mod that will not only add a little bit of safety, but also a touch of customization. I'm referring to this 3rd Brake Light Pulser fitting all 2010 and newer Mustangs. When installed, this 3rd brake light relay sends a signal to your 3rd brake light, causing it to pulse or blink while you're stepping on the brakes. It also features a delay repeat circuit, meaning the brakes have to be off for 15 seconds before the 3rd brake light starts pulsing again. This is just to insure that your 3rd brake light isn't going crazy while you're stuck in traffic, or if you're stepping on the brakes for a prolonged period of time. As I mentioned earlier, the Pulser is completely plug-n-play. What you'll need to do is unplug the harness from your 3rd brake light, plug your factory harness into one side of the Pulser, and then the other side of the Pulser goes into the 3rd brake light. It's that easy, getting everything done should take you no more than 30 minutes. Let's face it, there are a ton of distractions on the road today, whether it be cell phones, radio, navigation, whatever. People may not be as attentive as they should be behind the wheel, so anything you can do to keep both you and your Mustang safe is well worth it. So if you're looking to add a nice little safety feature to the rear end of your 2010 and newer Mustang that's inexpensive, and easy to install, then be sure to check out this 3rd Brake Light Pulser, right here at AmericanMuscle.com.
... READ MORE
OUR PRICE$59.99
Market Price $69.99You Save 14% ($10.00)
Item # 99035
AmericanMuscle no longer carries the Brake Light Pulser - Plug-in (10-14 All). Please check out 10-14 Mustang Tail Lights for an updated selection.
Email

Product Features

  • Improves Vehicle Safety
  • Exceptional electronics
  • Easy plug-n-play installation
  • Fits all 2010-2014 Mustangs
Added Vehicle Safety. A Third Brake Light Pulser will add an extra level of safety making sure that you are seen when you apply the brakes with it's bright pulsating action.

Delay-Repeat. Featuring a "Delay-Repeat Circuit" the Brake Light Pulser has to be off for at least 15 seconds before it will cycle again. So when sitting in bumper-to-bumper traffic, the third brake light isn't always blinking.

Plug-N-Play. Installation of the Brake Light Pulser module is easy. It simply plugs into the harness of your Mustangs third brake light with no wires to cut or no adjustments to make.

Application. The Third Brake Light Pulser module fits all 2010 to 2014 Mustangs, including the V6, GT and Shelby GT500 models.

Installation Time:

(approx) 30 Minutes

Difficulty Level:

Simple installation for anyone.

What's in the box?

  • (1) Plug-in Light Pulser Module

What's in the box?

  • (1) Plug-in Light Pulser Module
checkmark
Fitment:
  • V6 10, 11, 12, 13, 14
  • GT 10, 11, 12, 13, 14
  • GT500 10, 11, 12, 13, 14
  • Boss 12, 13

Customer Reviews