Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install MMD Tail Light Trim - Carbon Fiber on your Mustang

Installation Time

15 minutes

Supplemental Installation Instructions for 
MMD Carbon Fiber Exterior Accessories 
This supplemental guide is to be used in addition to the full installation guide included with your purchase. This guide will ensure that the 3M adhesive tape bonds properly to both the product and the vehicle and does not come loose from the vehicle. 
Stepl: Using the supplied alcohol prep pads, thoroughly wipe down the areas of the part where the adhesive tape will be applied. 
Step 2: Once the alcohol has dried (30-60 seconds), wipe the surface with the included 3M Adhesion Promoter Pad. 
Step3: Wait 60 seconds for the Adhesion Promoter to dry then apply the included 3M tape as shown in the photos below. You may now proceed with the main installation guide that shows how to apply the product to the vehicle. 

71326-77 / Antenna Cover (05-14) 

41271-77 / Tail Light Trim (10-12)


71324-77 / Tail Light Trim (13-14)


71326-77 / Antenna Cover (05-14) 


71332-77 / Emblem Surround (10-12)


71336-77 / Roof Spoiler (05-14)


71329-77 / Ducktail Spoiler (10-14) 


There is a roll of 3M tape provided with this spoiler. Cut the tape to proper length and apply around the outer edge on the underside of spoiler. 

Best Sellers