How to Install MMD Tail Light Trim - Carbon Fiber on your Mustang

1. Use the supplied alcohol pads to thoroughly wipe down the areas where the adhesive tape from the tail light trim will contact the light. 

2. Peel the backing away from 3M tape as shown.

3. Beginning with the outside edge, carefully place the trim over the tail light, making sure to align the edges of the trim with the edges of the LED surrounds on the light. Do not press down at this point to fully seat the adhesive. 

4. Once the trim is properly located, firmly press down to fully seat the adhesive tape.

5. Repeat Steps 1-4 for opposite side trim to complete the installation.