FREE 1 to 3-Day Delivery on Orders $119+ Details
Best Sellers
How to Install an MMD by FOOSE Rear Spoiler - Pre-painted on your 2015-2016 Mustang
Installation Time
2 hours
Tools Required
- Alcohol Wipes
- Adhesion Promoter
- Drill and Bits
- Panel Removal Tool
- 4 Foam Pads
- 4 Bolts and Washers
- 4 Drill Templates
Shop Parts in this Guide
**NOTE:
Convertibles with stock spoilers will still require drilling.
1
Using the provided drill template, remove the center adhesive contact. Place the adhesive side on the spoiler, centering it over the bolt hole.
2
Center all 4 drilling templates over each of the 4 mounting points.
3
Remove the deck lid panel. There are various push pins, the rubber bumpers located at the top unscrew. I was able to sneak the liner off by manipulating it around the latch trim.
4
Test fit the spoiler and center it on the deck lid. Then tape the template to the deck lid where they lay. Carefully remove the spoiler from the templates. *Note: this is the most important step so that the holes are drilled in the correct place.
5
Once the spoiler is removed, carefully drill the center of the template holes. Finish with a 7/32's drill bit. * Note: Use nail polish to cover any exposed metal to prevent rusting.
Place the supplied foam pads over the mounting holes on the spoiler. Trim as needed. Remove tape backing and install the wing using the provided hardware.
