Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install MMD ABS Rear Window Louvers on your 2005-2014 Mustang

Installation Time

1 hours

Tools Required
  • 8mm Wrench or Socket
  • Painters Tape

Contents:


(1) - Rear Window Louver
(8) - Mounting brackets


Tools Required:


8mm Wrench or Socket
Painters Tape


Before beginning, be sure to thoroughly
clean the rear window to remove dirt and
any other debris that may prevent the tape
to bond properly.

1. Wipe down the outer edge of the rear window with the supplied alcohol prep pads where the louver brackets will adhere. Once dry, follow with the supplied 3M Adhesion Promoter.


2. Install the supplied brackets onto the louver loosely as shown, do not fully tighten the nuts yet. Make sure install the brackets so the louver completely covers them when installed on the window.


3. Open the trunk before installing louvers. Pull the backing from the 3M tape on the brackets and place the louvers over the rear window (Do not let the tape adhere to the window yet). Line up the corners of the louver with the upper corner of the rear window as shown.


4. Once the louvers are in the proper position, firmly press down to fully seat the adhesive tape on the brackets. Using an 8mm socket and ¼” drive, tighten the nuts to secure thelouvers to the brackets. Do not overtighten the nuts, just past snug is enough. Cleaning: To clean your rear window, simply remove the 8mm  nuts/washers and remove the louver from the vehicle.


Best Sellers