Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How To Install Mustang Mirror Covers (05-09 All)

Installation Time

20 minutes

Tools Required
  • Cleaning Supplies
  • Rubbing Alcohol (optional)
  • Microfiber Cloth (optional)

Provided:


 Mirror Covers
 3M double sided tape
 Alcohol Swabs
 Adhesion promoter


Tools Needed:


 Cleaning Supplies
 Rubbing Alcohol (optional)
 Microfiber Cloth (optional)


1. Test fit your mirror covers (and maybe throw a coat of wax on them).


2. Using the provided alcohol pads wipe down the insides edges of the mirror cover. Then apply the provided adhesion promoter.


3. Evenly apply the 3M tape to the back of the cover. The tape is cut into three specific lengths, make sure and apply them to the proper sides.


4. Clean the factory mirrors to make sure there is no dirt, grime or bugs on them. With the mirrors clean and dry wipe down the factory mirrors with alcohol pads. If you run out use rubbing alcohol on a microfiber cloth.


5. Peel the backing off of the 3M tape pieces. Then carefully and lightly install the cover over the factory mirror in the desired location. With the mirror in the desired position firmly press down on the edges to fully seal the tape.


6. Repeat the steps on the opposite side to finish the installation.


Installation Instructions written by AmericanMuscle Customer Ryan McGill 9.10.14

Best Sellers