Talk to a Mustang Expert
1-888-332-7930
Mon-Sun 8:30 AM - 11:00 PM EST

Free Shipping On Orders Over $49. Details

How to Install a Stainless Steel Side Scoop Insert Set a 1999-2004 Mustang GT and V6

Installation Time

15 minutes

Tools Required
  • Flat Head Screw Drive.
American Muscle
Shop Parts in this Guide

Installation Instructions:

1) Place your flat head screw driver towards the top of the honey comb insert. Lightly pop it out of place; lifting up on the rest of the insert removing it from the car. Repeat on the other insert. 


2) Open up the packaging containing your new inserts. Peel back the red 3M plastic backing.


3) Line up your new insert on top of the original insert. Firmly press down around all edges and in the center of the insert. This will make a good seal when you hear popping (air escaping from between the inserts). 


4) Repeat steps 2 and 3 for the other insert.  

5) Once both inserts have been applied to the stock inserts it’s time to reinstall them back on to your car. Starts by placing the bottom hook into its appropriate spot. 



6) Push the rest of the insert into the scoop. You should hear a few clicks; popping the insert in place. Repeat this on the other side of your car to complete your new installation.  

7) Step back and admire the new look of your mustang! 


This guide applies to Vehicle years: 1999, 2000, 2001, 2002, 2003, 2004 and Submodels: GT, V6