How to Install Barricade 6 in. Oval Straight Side Step Bar - Gloss Black on your F-150

1.REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONSCAREFULLY BEFORE STARTING INSTALLATION.

2.Starting on the driver side of the vehicle, locate the (2) holes in the pinch weld to find the factorymounting holes in the inner side panel, (Figure 1). NOTE: The inner holes may be covered with sealingtape or insulation. Slide the 8mm Clip Nuts into the opening with the nut towards the inside. Line up thethreaded nut on the clip with the round holes, (Figure 1).

3.Partially attach the driver side Mounting Bracket to the Clip Nuts with the included (2) 8mm x 30mmHex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figure 2). Depending on model andyear, the brake cable may be run on the inside or outside of the Bracket. Do not tighten hardware atthis time. NOTE: The Cradle on the Front Mounting Bracket should face to the rear of the vehicle.

4.Align the bottom holes in the front Mounting Bracket with the (2) holes in the pinch weld. Bolt theBracket to the pinch weld using the included (2) 8mm x 30mm Hex Bolts, (2) 8mm Lock Washers, (4)8mm Flat Washers and (2) 8mm Hex Nuts, (Figure 2). NOTE: Insert the bolts up from the bottom of thepinch weld and through the Bracket.

5.Repeat Steps 2 – 4 for Rear Mounting Bracket installation. NOTE: The cradle on the Rear MountingBracket should face the front of the vehicle, (Figures 3 & 4). The mounting holes will be the last settowards the back of the cab.

6.Carefully position the Sidebar onto the Mounting Brackets and attach it using the included (4) 8mm x25mm Hex Bolts, (4) 8mm Lock Washers and (4) 8mm Flat Washers, (Figure 4). Do not tightenhardware at this time.

7.Level and adjust the Sidebar properly and tighten all hardware.

8. Repeat Steps 2 – 7 for passenger Sidebar installation.

9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.  For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the Sidebar. 

For gloss black finishes: Mild soap may be used to clean the Sidebar.