Installation Time: Less than 1 Hour
May 10, 2013
Third Brake Light Trim
My piece had a slight bend (not kink just a bowing) of one of the long sides. I thoroughly cleaned the area around the brake light with a soft cloth (old diapers washed-NO Fabric Softener or Drier Sheets) with rubbing alcohol ($1 at grocery). I anchored the straight long side to the top of the 3rd brake light as well as the 2 ends without uncovering the tape on the slightly bowed side. I let it sit a couple minutes to make sure it was set, then gently removed the tape making sure to hold the bottom long side away from the car, when all the tape was removed, I gently pressed it in place making sure to straighten out the slight bend. Not rocket science or difficult, just practice it before you pull the protective layer off the tape-that 3M stuff is GOOD. With the Chrome brake like covers and this trim piece, dresses up the butt of my '14GT a bunch. Highly recommended.