Talk to a F-150 Sales Tech
1-888-706-1096
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

How to Install N-Fab Wheel 2 Wheel N-Durastep - Semi-Gloss Black on your F-150

INSTALLATION:

Step 1: Starting with the Driver Side. Remove all 8mm flange nuts from the 8mm factory threaded studs to remove the OE running boards. Repeat for passenger side. (Fig.A). 


Step 2: Locate the driver Side Nerf-Step. The longer bend end and or the straight capped end go toward the rear of the vehicle.


Step 3: Carefully raise Nerf-Step into position and align the three brackets with the nine 8mm OE threaded studs.


Step 4: Using the supplied 8mm flanged nuts, fasten all nine mounting positions. Leave loose at this time. (Fig.B) 


Step 5: Staring with the rear bracket, push up towards the pinch weld so the 3” main bar is as high and tight to the body as possible. Tighten all three 8mm flanged nuts.


Step 6: Move to the front bracket and repeat same step. Finsh by securing the center bracket.


Step 7: Repeate steps 3-6 for passenger side. Your install is now complete.