How to Install PIAA Trail Light Mounting Bar on your F-150

Hardware Kit Contains:

2) 3/8” x 1” Hex Head Bolts

2) 3/8” Washers

Step 1: Remove the pre-installed hardware from the lightbar. Hold the Light Bar up to the face of the bumper where the round mounting brackets are 􀏐lat against the bumper. Use the top of the bumper to align the Light Bar perpendicular to the ground.

Step 2: While the Light bar is positioned on the bumper, mark around the two mounting
brackets onto the bumper. Next, remove the light bar and set aside. You should have two circular marks on the bumper.

Step 3: Mark an ‘X’ through each circle, this will give you the center. Use a metal punch
and hammer to punch a pilot hole through the center of the circle.

Step 4: Drill a ½” hole through the pilot marks. NOTE: Make sure the holes are free of
metal burrs.

Step 5: Align the Light Bar mounts to the drilled holes and place a 3/8”x 1” bolt and the
3/8” washer through the back side of the bumper and thread into the light bar bracket.
After 􀏐inal positioning, torque each bolt location to 15-20 ft/lbs. NOTE: Removing the
bumper may be easier on some models.