1-866-727-1266Talk to a Mustang Expert
Check Out
shopping cart
Free Shipping

CDC 2005+ Mustang Deck Lid Trim Panel Installation Guide

AmericanMuscle Installation Garage


The below installation instructions work for the following products:
AmericanMuscle Installation Garage
Here at American Muscle, we're all about DIY (do it yourself). Of course, there's nothing wrong with seeking out a little bit of tech help prior to taking on an installation on your own. Our Mustang installation guides will provide valuable instructions and hopefully answer any how-to questions that you may have along the way.







The following instructions are for the installation of the CDC Deck Lid Trim Panel and the CDC Deck Lid Trim Panel with GT logo for the 2005+ S197 Mustangs.

Tools Required:

  • Razor scraper
  • Isopropyl Alcohol (rubbing alcohol)
  • Heat gun or Hair dryer
  • Small prying tool

Installation:

Removing Rear Emblem
  1. Tape area around emblem. (Figure 1)

  2. 01

  3. Warm emblem with a heat gun or hair drier.

  4. Insert a plastic or wooden wedge between the emblem and deck lid to remove. (Figuer 2)

  5. 02

  6. Then rub off the solid glue from where the emblem was with Isospropyl Alcohol.

  7. Place the key hole black out sticker around the key hole.

  8. 05

    NOTE: MAKE SURE THE AREA IS CLEANED WITH ISOPROPYL ALCOHOL


Installing Rear Deck Lid Trim Panel:

    NOTE: BEFORE YOU DO ANYTHING ELSE CLEAN THE WHOLE TRUNK LID WITH ISOPROPYL ALCOHOL, AND MAKE SURE IT IS ALL CLEAN. IF THIS IS NOT DONE THE GLUE ON THE COVER WILL NOT HOLD PROPERLY.

    KEEP THE CAR IN THE SHADOW FOR 20 MINUTES SO THE TRUNK LID CAN COOL DOWN.

  1. Center the Trim Panel on Deck Lid side to side. The Trim Panel should be approximately 1/16" from the edge on both sides and along the bottom of the Deck Lid. Once proper location has has been achieved, press Trim Panel to deck lid while pulling the red backing from behind the Trim Panel. Firmly press on Trim Panel to seat Acrylic Tape.

  2. Let the car sit for about 2 hours before driving so the glue can bond then double check the Trunk Deck Lid before driving.

  3. 07

    Finished Installation


    Installation instructions provided by AmericanMuscle customer by Emin Hodzic



Mustang Catalog

Why Shop AM? Free Shipping - No Hidden Costs Real Time Inventory - No Backorders Knowledgeable Staff Award Winning Service Free Mounting and Balancing With Wheel and Tire Purchase
vendors Stack RacingDiablosportBBK PerformanceHawk Brake PadsView All Authorized Vendors

See Us Featured in Mustang Magazines