How to Install AEM Brute Force Cold Air Intake - Gunmetal on your Mustang

Prepare Vehicle

• Park on level surface
• Set parking break
• If engine has run within the past two hours let it cool
• Disconnect negative battery terminal
• Remove Stock Intake System

*DO NOT TIGHTEN HOSE CLAMPS UNTIL INSTRUCTED TO DO SO / With Exception of PCV & IAC Hose Clamps
*The screen will not be reused with the MAF sensor

Step 1

• Attach AEM coupling and hose clamps

Step 2

• Insert AEM Inlet Pipe into coupler

Step 3

• Attach IAC hose and secure with provided hose 5/8” hose clamps
• Attach AEM provided breather hose for PCV and secure with hose clamps

Step 4

• Assemble Air horn/ MAF sensor adapter to bracket
• Install provided gasket between MAF Sensor and AEM air horn
• (The MAF sensor has an airflow arrow marked on it; the bracket should point towards the same direction)

Step 5

• Attach coupler and hose clamps

Step 6

• Loosen Bolt, attach bracket with bolt provided. The bracket’s slot should be between the washer and stock bracket

Step 7

• Attach inlet pipe and coupler with provided clamps

Step 8

• Connect AEM Air Filter to coupler with Large Hose Clamp

STEP 9

• Tighten hose clamps
• Inspect vehicle for loose parts
• Make sure you have proper hood clearance when closing the hood
• Reconnect Negative Battery
• Idle vehicle for 3 minutes
• Test Drive Vehicle
• Enjoy!