Black Friday Sale Shop Up To 60% Off
Talk to a Mustang Expert
Mon-Thu 8:30am-11pm, Fri 7am-11pm Sat-Sun 9am-7:30pm

Free Shipping on Everything. Seriously. Details

How to Install MMD Tail Light Trim on you 1994-2004 Mustang

Installation Time

15 minutes

Tools Required
  • Alcohol Prep Pads (included)
American Muscle
Shop Parts in this Guide

Before beginning, thoroughly clean the tail
light lens to make sure they are free of any
dirt or contaminants.

Step 1 

Open the trunk of the vehicle to allow for
easier installation. Use the supplied
alcohol pads to thoroughly wipe down the areas where the adhesive tape from the tail light trim will contact the light.

Step 2

Peel the backing from the 3M tape as
shown above.

Step 3 

Beginning with the inside edge and working towards the outside, carefully place the trim over the tail light. Do not press down at this point to fully seat the adhesive.

Step 4

Once the trim is properly located, firmly
press down to fully seat the adhesive tape.

Step 5

Repeat Steps 1-4 for opposite side
trim to complete the installation.

This guide applies to Vehicle years: 1999, 2000, 2001, 2002, 2003, 2004 and Submodels: Bullitt, Mach 1, V6, Cobra, GT