Accufab 70mm Polished Throttle Body (96-04 GT)

1996-2003 Mustang GT 4.6L 2V Throttle Body & Plenum. The new Accufab 70mm Mustang GT Throttle Body & Plenum can benefit any 1996 to 2003 4.6L 2V engine. Independent dyno tests on a completely stock 4.6L GT have shown an increase of up to 11 additional horsepower, with additional torque and no loss to bottom end performance.

Features:

• CNC billet aluminum and highly polished
• Bolt-On 5+ Horsepower In Just Minutes
• CUT From The Highest Quality 356 Aluminum
• State-of-The-Art CNC Machining.
• Improved Throttle Response.
• All units are designed as a direct-replacement, and require no other modifications.

Reviews:

"Added this to my 2001 GT which had C&L MAF and inlet pipe. Product looks great with my C&L parts. Sound is slightly deeper and throatier. Best part is that my rpm's stay higher between shifts now. No problems with installation or idling afterwards. Install time about 25 minutes."

"No whistle, no sticking, has much better feel than stock. Beautifully pollished outside and inside. Went really nicly with Edelbrock Performer intake. Everything just bolts over."

We now carry the NEW Accufab 70mm plenum, for the ultimate intake combination! Combined power of 10HP / 15TQ on bolt on GT!

NOTE: Idle Speed should only be set by adjusting the Throttle Position Sensor. DO NOT adjust any screws on the Throttle Body. These screws are pre-set at Accufab.