Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install a Center Console Round Access Plug on your 1987-1993 Mustang

Installation Time

15 minutes

Tools Required
  • Trim and molding tool set
  • A very small flathead screwdriver, but not recommended.
American Muscle
Shop Parts in this Guide

Installation Instructions:
1. The center console is easy to take apart. To take it off get in the back seat.


2. Take your plastic trim tool (or very small flat head screw driver) and very carefully put the tool under the end of the access plug and lift up. Do not use too much force because you do not want to break them.


3. To take the other one off, do the same thing.


4. There are four bolts (two on each side) to take off if you wish to take the center console out. You need a 5/16 socket to do this.


5. To take the center console out, you must simple pull back toward the rear of the car and lift up at the same time. It should come right out.


6. To put the center console back in you need to put the bottom in first. There are three tabs that need to go into the holes first, then you can put the top side in.


8. Put the screws back in, take your 5/16 socket, and tighten the bolts.
9. To put the new access plug covers in, just place them over the hole and push them in. You can also smack them with the palm of your hand too.
10. Smile! You’re done!!!

Best Sellers