How To Install Mustang Rear Brake Caliper Bolts on Your 2005-2011 Mustang

Installation instructions:

1. Gather materials necessary for installation. (Ratchet and socket not pictured)

2. Break your lug nuts loose

3. Jack your vehicle up

4. Place jack stand under your car for support

5. Proceed to take your lug nuts off your wheel

6. Take your tires off your car.

7. OPTIONAL: You can place your tires under you’re car while working for added protection in case of jack stand failure

8. Using a 13mm socket, remove the two bolts that hold in the top portion of the caliper

9. Take the old bushing off of the old slide pins and transfer them to the new slide pins

10. Now is a good time to coat the new slide pins with the left of lube from the old slide pins

11. Insert the new slide pins along with the bushings into the top caliper bracket. NOTE: You must correctly align the flat side of the new slide pins with the caliper bracket.

12. Insert the new 13mm caliper bolts

13. Tighten down the new 13mm caliper bolts

14. Check the caliper to ensure proper fitment and correct installation

15. Put your wheels back on your car

16. Install your lug nuts by hand

17. Remove your jack stands

18. Lower your vehicle to the ground

19. Tighten your lug nuts with your tire iron

20. Enjoy your new set of Rear Brake Caliper Bolts

Installation Instructions written by AmericanMuscle customer Laurence Arroyo 7.24.2014