Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install Cervini's Rear Window Louvers - Aluminum (05-14 Coupe) on your Ford Mustang

Tools Required
  • Phillips Screwdriver
  • Pen
  • Masking Tape
  • Scissors
  • 11/32 Wrench
  • Tape Measure

Louver Install

1. Clean Window with Isopropyl Alcohol. Place a 5” piece of masking tape on center top edge of glass. Mark center of glass on tape with a pen.

2. Cut Out Template. Center and tape it on upper part of glass.

3. Apply adhesion promoter in upper pad areas. Close the packet to slow evaporation.

4. Peel the tape from the hinge pads and mount in place.

5. Burnish with the back end of a screw driver.

6. Attach the Hinges to the louver at the top about 9/16” from the bottom of the hinge pads. Put washer plates over hinges and apply the nuts loosely. Then align the louvers so they fit aligned to the glass at the top and centered in the window.

7. Tighten the hinge nuts with 11/32” wrench.

8. Secure the latch pads on the lower latch clips. Lower the louver to check pad locations while pressing on the lower center to hold the feet down. Then use masking tape to frame the area and apply promoter to the area, and stick in place.

9. Slip Corner Clips beneath the louver’s top corners. Touch to glass to secure when in position. Allow 24 hours for tape to cure prior to exposing to direct sun or freezing conditions.



Note: Allow 24 hours for adhesive to cure prior to exposing to direct sun or below freezing conditions

Best Sellers