Free Shipping On Orders Over $49. Details

Talk to a Mustang Enthusiast
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P

Best Sellers

How to Install a Door Panel Push Pin Kit in Your 1979-1993 Mustang

Installation Time

10 minutes

Tools Required
  • 1 Pair of Hands
American Muscle
Shop Parts in this Guide

Time Needed: Aprox 10 min


Tools Needed: One pair of Hands
A trim and molding tool set is not needed but would work as well to remove any push pins that may have broken off into the door.


Removal Process


Step 1: Looking at the Back of the door panel locate the old push pins that need replacing.


Step 2: After locating the worn pins you will see hole in the panel board next to the push pin, the hole you can see is connected to another smaller hole where the push pin is currently at. To remove the old pin push the pin into the larger hole.


Step 3: pull straight out to remove pin from the panel board.


Step 4: repeat on all other push pins that need to be changed out.


Installation


Step 1: Take your new push pin and put it in the larger one of the two holes.


Step 2: Slide the push pin into the smaller hole until it stops.


Step 3: repeat on all other spots that need new push pins.


Step 4: After all Push pins have been replaced line the pins up with the corresponding holes on the door and push in one at a time.


Step 5: enjoy your door panel now being connected to your door.



BEFORE

AFTER

Installation Instructions written by AmericanMuscle Customer Vance Clarke 9.22.2014

Best Sellers