Edelbrock Performer EFI Intake Manifold (86-95 5.0L)

7 More Questions

Will this fit on my 95gt Convertible with the stock strut bar? 1 answer

• The Edelbrock Performer EFI Intake Manifold will not work with the stock strut tower brace no. You will need the Edelbrock's Strut Tower Brace part# 5225 for clearance.

Helpful (0) Thanks for your input!

Work on 95 cobra with Edelbrock heads ? 1 answer

• The 1994 to 1995 Mustangs will require the use of the Edelbrock Throttle Body Adapter part# 3835 and replacing the stock strut tower brace with Edelbrock's Strut Tower Brace part# 5225 for clearance to allow this Edelbrock Performer EFI Intake Manifold to fit.

Helpful (0) Thanks for your input!

Will a 75mm throttle fit with this intake on a 95 gt 1 answer

• Yes, The Edelbrock Performer EFI Intake Manifold will accept a 75mm throttle body. You will need an adapter which will allow for you to fit the throttle body onto the SN95.

Helpful (0) Thanks for your input!

Will this fit my 89 f150 5.0 1 answer

• Unfortunately, we can only guarantee fitment for the Edelbrock Performer EFI Intake Manifold on 86-95 5.0 Mustangs.

Helpful (0) Thanks for your input!

I have now had the intake instaled but after picking up the car I am getting a little smoke when i start up out the exaust now that was not there before.I have a 93 gt convertable.I seem to be going through a little more oil also.Any ideas? thanks for your help. Fred 1 answer

• This could be a handle full of issues that could be causing this. We would highly recommend taking your vehicle back to the installer as it was not smoking prior its installation.

Helpful (0) Thanks for your input!

Is this Intake good with GT 40 heads X and a E 303 cam 1 answer

• Yes, my car has ported gt40s with valve job and e303, and it is very streetable, once you get into the power band it pulls so great.

Helpful (0) Thanks for your input!

what would be a good Throttle Body for Edelbrock Performer EFI Intake Manifold for a 89 3 answers

• It depends on the other mods you have done to your car. If you have just basic bolt-ons (exhaust, CAI, etc.) a 65 MM would be fine. If you have heads and cams I would go with a 70 MM and if you have a blower I would go with a 75 MM.

• i had this intake a while back on my 93, and I ran it with a BBK 70mm throttle body. a 75mm will be too big for the intake port of the intake manifold itself and a 65mm will be too restrictive.

• 65 mm tb if use is for street, maybe a bit more responsive. But can't go wrong with either a 65mm or 70mm. 75 if u go to the track

Helpful (0) Thanks for your input! Show 2 more answers