Free Shipping On Orders Over $49. Details

Talk to a Mustang Enthusiast
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Win $5,000 For Your Mustang! Enter Daily

Best Sellers

How To Install a Hands Free MP3 Adapter on your 1987-2006 Mustang

Installation Time

45 minutes

Tools Required
  • 3/8” Drive Ratchet
  • 8mm socket
  • 15mm Deep Socket (if you want to remove your driver seat)
  • Plastic Trim Removal tool*
  • Zip Ties (optional)
American Muscle
Shop Parts in this Guide

These Installation instructions work for all 99-04 Mustangs 

Step One

(Optional) Remove Drivers seat by unbolting the 4 15mm bolts.

Step 2

Remove gear knob, shifter bezel, center radio bezel

Step 3

Unclip all accessories (Fog lights, trac cont., rear defrost, cig lighter) 

Step 4 

Unbolt 8mm bolts holding the radio unit in place. (They are the two outer bolts on the aluminum tabs) 

Step 5

Gently remove the radio and unclip all radio harnesses and the antenna (Orange cord) 

Step 6 

Connect the black antenna cable to the radio; connect the orange antenna cable to the Hands free MP3 

Step 7 

(Optional) Using Zip Ties, hang the Hands Free MP3 Me from the radio mounting bracket 

Step 8A 

Start routing the cables where you want them to be accessed from. I later tucked the cord under the center console trim 

Step 8B 

Start routing the cables where you want them to be accessed from. 

Step 9 

Unwind the black and red cables, route the red cable to the fuse box under the driver’s side dashboard. You will need to bend the end a bit to get the fuse panel protector back on. 

Step 10 

Find a good ground point for the black wire. (I used this factory ground point on the right side of the Drivers Dash board, just past the OBD 2 jack.) 

Step 11

Reverse steps 5 through 1.

That’s it; enjoy your smart phone or other device in the car! Be sure to set your device to 3⁄4 max volume. 

Best Sellers