Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

Mach 1 Chin Spoiler Installation Guide

Installation Time

30 minutes

Tools Required
  • Masking tape or Duct Tape
  • Drill
  • 1/4" Drill Bit

Installation

’94-’04 Mach 1 Chin Spoiler Install

1. Raise front of vehicle using ramp, hoist, or by using a jack with jackstands.DO NOT ATTEMPT TO INSTALL THIS IF YOU ARE NOT USING JACKSTANDS! SERIOUS INJURY CAN RESULT!

2. Take the chin spoiler and line it up flush with the edge of the wheel well. Tape the Chin Spoiler in place so that it stays and you can drill the holes that will be used for the push pin fasteners that will hold the spoiler in place.

3. Once the chin spoiler is taped into place, check fit along front edge.

Note:Chin Spoiler will be flush with the fascia for about 4 to 5” from wheel opening then it goes behind the leading edge of the fascia.

4. When Spoiler is evenly spaced on fascia, drill ¼” holes into fascia at each Chin Spoiler screw location. Insert pushpin fasteners into the fascia to secure the chin spoiler to the fascia. It’s easiest to insert them right after you drill.

5. Remove tape.

6. Flaunt your car.


How to Install a Mustang Mach 1 Chin Spoiler - Video Installation Instructions
AutoHow.tv, AmericanMuscle's video sponsor - http://www.autohow.tv/node/35

Best Sellers