How to install an MMD V Series Rear Spoiler - Pre-Painted on your 2015-2016 Mustang

**NOTE:
Convertibles with stock spoilers will still require drilling.

STEP 1:

Using the provided drill template. Remove the
center adhesive contact. Place the adhesive side
on the spoiler, centering it over the bolt hole.

STEP 2:

Center all 4 drilling templates over each of the 4 mounting points.

STEP 3:

Remove the deck lid panel. There are various push pins, the rubber bumpers located at the top unscrew. I was able to sneak the liner off by manipulating it around the latch trim.

STEP 4:

Test fit the spoiler and center it on the deck lid. Then tape the template to the deck lid where they lay. Carefully remove the spoiler from the templates. **Note: this is the most important step so that the holes are drilled in the correct place.

STEP 5:

Once the spoiler is removed, carefully drill the center of the template holes. Finish with a 7/32’s drill bit. **Note: Use nail polish to cover any exposed metal to prevent rusting.

STEP 6:

Place the supplied foam pads over the mounting holes on the spoiler. Trim as need. Remove tape backing and install the wing using the provided hardware.