Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install a Raxiom Directional Sideview Mirrors on your 2005-2009 Mustang

Installation Time

1 hours

Tools Required
  • 6mm-11mm Sockets
  • 7/16" Socket
  • Flathead Screwdriver
  • T-30 Torx Driver
  • Wire Stripping/Crimping Tool
American Muscle
Shop Parts in this Guide

Tools Required:


► 6mm-11mm Sockets
► 7/16” Socket
► Flathead Screwdriver
► T-30 Torx Driver
► Wire Stripper/Crimping tool

Mirror and Door Panel Removal -- Driver and Passenger Side


Step 1: Remove the driver’s side mirror control panel by pulling away from the door


Step 2: Disconnect the harness connecting the door to the mirror control panel


Step 3: Remove the 3 Bolts holding the old mirror in place.


Step 4: Pull the inner door handle out and pop the inner cover out exposing the torx screw below.


Step 5: Pull the window control assembly towards the interior of the vehicle to remove it.

Step 6: Disconnect the wiring harness connected to the window switches and remove the 7mm screw behi



Step 7: Using your fingers or interior trim removal tools, pull the panel behind the door pull out and up to remove it from the vehicle.


Step 8: Remove the T-30 torx screw behind the door pull and the door handle.


Step 9: Remove the 7mm screws located around the outer part of the door panel and pull the panel up and away from the door.


Step 10: Unplug all connectors holding the panel to the door leaving the door handle cable attached.

Raxiom Mirror Wiring Directions -- Driver and Passenger Side


Step 1: Route the wire through the door panel and into the harness that passes through the vehicle.


Step 2: Remove the interior kick panels and door sill panels.


Step 3: Using a stiff wire tool, route the tool into the harness to pull the wires into the interior of the vehicle.


Step 4: Locate the wiring harness that runs down each door sill and expose the wires within.


Step 5: Wire the mirrors into the vehicles harness using the supplied wire splices.

DRIVERS SIDE – Tap into the WHITE/RED wire with the positive (red) and ground the black wire to the black wire in the harness


PASSENGER SIDE – Tap into the DARK PINK/WHITE wire with positive (red) and ground the black wire to the black wire in the harness


Step 6: Test the mirrors to ensure proper operation.


Step 7: Install the Raxiom Mirrors and reverse steps 1-10 in the previous section to reinstall the door panel.

Best Sellers