Installation Time: Less than 1 Hour
February 15, 2017
Dresses up the back bumper
As has been mentioned, installation is very easy, but be sure to do your prep work. After washing the back bumper, I used isopropyl (rubbing) alcohol to completely remove any dirt or wax from the indented area before starting to install the letters. Squeeze four or five drops of dishwashing detergent in a spray bottle filled with water before and wash the entire bumper, then use the alcohol. Spray the individual letters liberally with the soapy water and peel them from the paper. Before affixing them to the bumper, also spray the bumper. Do not skimp with the soapy water, the more, the better, and be careful peeling the letters 'S' 'A' and 'G' off the paper so as not to fold them over themselves. Once the letter is applied, spray it again and smooth all the air bubbles out with your wet fingers. Pay special attention to the edges of the letters and make sure they are totally flat and affixed to the bumper. Hold the letter in place with one hand while smoothing it out with the other. When done the black letters pop on the while bumper of my 2004 Vert.