Talk to a Mustang Sales Tech
1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install SR Performance Black Strut Tower Brace on your Mustang

Tools Required
  • Metric Socket Set
  • Torque Wrench
American Muscle
Shop Parts in this Guide

Contents:

(1) Strut Brace

(4) M10x1.5 Nuts

(4) M10x1.25 Nuts

(8) M10 Washers

(6) Spacers

Step 1:  Begin by removing the battery cover trim panel. and disconnecting the positive battery cable. Remove the clip holding the battery cable to the strut tower. 


Step 2:  Remove the (2) M10x1.25 nuts from the upper strut  mount on both sides. 

**Note: There are M10x1.25 and M10x1.5 Nuts it is very important that the newly supplied nuts are installed on the correct studs otherwise you will cross thread the stud. 



Step 3:  Next, remove the (2) M10x1.5 Bolts from the painted chassis brace studs on both sides. Performance Pack cars will have this brace on both sides. Non-Performance Pack cars will only have this brace on the passenger side. 

**Note: There are M10x1.25 and M10x1.5 Nuts it is very important that the newly supplied nuts are installed on the correct studs otherwise you will cross thread the stud. 


Step 4:  Place the supplied spacers on any studs that do not already have a black chassis brace. The picture below shows what the chassis brace looks like. 

Non-Performance Pack cars will get (6) spacers total. (2) on the passenger side and (4) on the driver side.

Performance Pack cars will get (4) spacers total. (2) on each side.  


Best Sellers