Free Shipping On Orders Over $49. Details

Talk to a Mustang Enthusiast
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Win $15,000!! Enter Now

SpeedForm Magnetic Decklid Blackout Panel (10-12 All)

Item 79999
AmericanMuscle no longer carries the SpeedForm Magnetic Decklid Blackout Panel (10-12 All). Please check out Ford Mustang Decklid Trim Panels for an updated selection.
Call a Mustang Enthusiast at 1-877-887-1105
M-F 8:30A-11P, Sat-Sun 8:30A-9P

    Review & Installation Video

    Hey, what's going on, guys? Adam here with, and today I'm bringing you a quick review of the Magnetic Deck Lid Blackout Panel fitting all '10 to '12 Mustangs. So the Magnetic Deck Lid Blackout Panel is going to be for the '10 to '12 S197 owner out there looking to get a bold, aggressive look for the rear of your pony while saving money and time on the install. So this Deck Lid Panel offers a sleek, classic styling reminiscent of the early '70s model deck lid.

    Product Information

    Features, Description, Reviews, Q&A, Specs & Installation


    • Sleek Classic Styling.
    • Weather Resistant
    • Easy Magnetic Installation - No Tools Required!
    • Fits All 2010-2012 Mustangs.


    Sleek Styling. The SpeedForm Mustang Magnetic Blackout Panel adds an extra level of sleek styling to the new 2010-2012 Mustangs. Now you can give your new pony the same black treatment as the classic mustangs of the early 70's.

    Fit and Finish. The SpeedForm Mustang Magnetic Blackout Panels are die-cut to the assure a perfect fit on the all 2010-2012 Ford Mustangs and has perfectly sized round opening to accommodate the rear GT emblem.

    Easy Magnetic Installation. Installation could not be any easier since it utilizes good old fashion magnetism, it can be installed and uninstalled at will. Now you can go from stock to show stopping in just seconds.

    This SpeedForm Magnetic Decklid Blackout Panel fits perfectly on all 2010 to 2012 Mustangs, including the V6, GT, and Shelby GT500 models.

    Technical Note.The Magnetic Panel is shipped rolled, when unboxed it is recommended to allow the panel to lay flat over night to retain it's original shape for even easier installation.


    Fitment: Details

    CA Residents: WARNING: Cancer and Reproductive Harm -


    Customer Reviews (100+)

    Write a Review

    Ratings Summary

    4 out of 5 overall rating from 100+ customers

    Installation Time: Less than 1 Hour

    • January 24, 2020

      1 2010 V6 - MiguelAG Installation Time: Less than 1 Hour

      It doesn’t fit correct

      It easy to put on but the cut doesn’t fit correct you have move around to make it fit. The circle cut doesn’t fit correct it leave a gap.

      Helpful (0)
    • January 16, 2020

      4 2010 V6 - AdamB9281 Installation Time: Less than 1 Hour

      Good Product

      Honestly it is a bit cheap, but for the price, it looks pretty sharp. Fit well after letting it stretch out a few days clinging to the fridge haha.

      Helpful (0)
    • January 12, 2020

      3 2012 V6 - JimP Installation Time: Less than 1 Hour

      Speedform Magnetic Decklid Blackout Panel

      Poor packaging. Item arrived in a large envelop, folded in half. The sharp top corners of the panel were sticking through the inadequate shipping envelope and were roughed up and nicked up. The magnetism is not uniform, as some of the item 'pulls' strongly, but the bottom 'corners' are magnetically weak, and I am worried that wind will pick the panel off the car at speed. I guess I will find out. Also, item center hole is a poor fit. The bottom edge is not cut straight, and does not cover the paint well on the left bottom half. From a distance, though, it looks good on the car, and enhances the tail-lights, but I am disappointed in the quality and fit. It's not the end of the world, of course.

      Helpful (0)
    • January 08, 2020

      1 2012 V6 - Brandon Installation Time: Less than 1 Hour

      Looks decent but bubbles your paint

      Ruins your paint underneath, doesnt fit perfectly.

      Helpful (0)
    • October 27, 2019

      1 2011 GT - JamesC Installation Time: Less than 1 Hour

      Waste of money

      It came folded so it has an un-removable crease in the center, the top corners were also folded in. It also doesn't fit well. Not putting it on my car.

      Helpful (0)
    • October 24, 2019

      1 2011 V6 - Harry Installation Time: Less than 1 Hour

      Don’t bother

      Just a magnetic piece that’s overpriced especially when it doesn’t even lineup with the emblem. Waste of trash. Even the quality is so bad. Not thick enough

      Helpful (0)
    • October 22, 2019

      1 2012 V6 - JohnA

      Not a good buy.

      Although this magnetic decklid stays in place, what they don't tell you is it collects dirt and road dust underneath it as you drive. Even though I drive very few miles on this vehicle and keep it clean I started to see noticeable bumps/raised areas on the decklid. Upon removing it, I could see what damaged it. It was the road debris collecting underneath it causing the deformities. You have to clean it daily, if driving daily, to avoid the problem.

      Helpful (0)
    • October 19, 2019

      1 2012 V6 - JimmyLe690

      It ripped

      I finally opened the box up and noticed it was folded in half. It had lines down the middle, where the decklid emblem would be, and I thought it would be fine. It finally ripped in half when I went to put it on the car. Pretty disappointed.

      Helpful (0)
    • October 08, 2019

      1 2011 V6 - MrBoo Installation Time: Less than 1 Hour

      Cheap looking

      I did not like the look. Looked cheap. Not worth the money.

      Helpful (0)
    • October 03, 2019

      2 2010 V6 - Rustang Installation Time: Less than 1 Hour


      I know it was cheap and a temporary cosmetic look but this was so poorly constructed... the middle by the emblem was so thin i thought it was going to break. It didn’t properly line up so it looked jagged and out of shape. Only reason for 2 stars is because it held on strong. Save your money and get a real one.

      Helpful (0)

    Questions & Answers (5 answers)

    5 Top Rated Questions

    Is there a magnetic deck lid coming for my 2013 Mustang ??

    • At the current time, there are no magnetic decklid panels available for the 2013 or 2014 Mustangs.

    Helpful (1)

    I have an MMD emblem emblem already installed...would I have to remove that to install the decklid panel? (I'm afraid I already may know the answer, but wanted to make sure). Thanks!

    I have a 2011 V6 that has the "slatted" style decklid that I believe is just hard plastic or rubber. How would this or any aftermarket decklid panel work for me?

    Has anyone tried this on the 13-14 GT's? Based off what I read, it appears that the only difference between the decklid's for the 2010-2012 is that there are some holes in the trunk for fastners. But for the most part everything is held by 3M, so I don't see why this panel couldn't work with a 14.

    • Unfortunately, the Magnetic Decklid Blackout Panel (10-12 All) is only designed for all 2010 to 2012 Mustangs. There is an issue with the curves not fitting perfectly together. This may not fit properly on a 13-14 GT.

    Helpful (0)

    Washing car with panel on? Can I keep it on the car while washing it?

    • You should not have any issues keeping it on while washing your car; however I would recommend removing it every now and then to clean around the edges.

    Helpful (0) Show 5 more answers
    Post Your Question

    Installation & What's in the Box

    Installation Info

    What's in the Box

    • (1) Magnetic Blackout Panel
      Hardware included:
    • None Required

    Tech Specs

    Will It Fit My Mustang

    • Boss 302 - 12
    • GT - 10, 11, 12
    • GT500 - 10, 11, 12
    • V6 - 10, 11, 12

        Related Mustang Categories