Safety and Strength. Add additional safety and strength to your uni-body Foxbody Mustang with a SR Performance eight point roll bar featuring 1-3/4" x .134" wall steel tubing. This Mustang roll bar meets NHRA requirements for track use.
Application. This SR Performance 8 point roll bar is designed to fit the 1979 to 1993 Hatchback or Coupe Mustangs. It is not intended for use on convertibles.
Technical Note. AmericanMuscle recommends professional installation of all Roll Bars and Roll Cages as welding is required for proper installation and safety. Ships unassembled.
Found item well priced everything was cut to fit and packaged well with guided instructions inclosed.. I wouldn't purchace antoher cage from any other dealer other than American Mussle. Looking forward ...
for more purchases..
In the product photo the rear bars are a straight angle bar goin down in a diagnal to the rear. the customer photos show the rear bar follows the roof line and then drops down through the rear shelf? which photo is correct for this cage? thank you
The rear bars are going to go along the roof then go down on an angle. The reason our photo just shows an angle is could be because of how the picture was taken. The roll cage will look like the one in the customer photos.
I understand this kit is pre cut but is it pre notched? Are the ends pre notched? How much fabrication by the customer will this kit need before its ready to be tac'd fully welded in place? Thanks!
The S&W 8-Point Roll Bar bases are not pre-notched, and will need to be notched by the installer. The cage will require some preparation however, the angles are notched for hold and tac for an easier preparation and installation.
Found item well priced everything was cut to fit and packaged well with guided instructions inclosed.. I wouldn't purchace antoher cage from any other dealer other than American Mussle. Looking forward for more purchases..
Went round and round with customer support and the floor plates.the pic shows them bent to fit the rockers. They dont. Comes with flat plates. Customer support was helpful and such. Still a happy customer with the service.
Really pleased with this kit overall. All parts of the cage that mount to the plates needed some work but all other angles were properly notched for hold and tac. Take your time to do the prep work right and this kit goes together very well.