Heat Shield Cold Air Intake with Red Filter (06-10 3.5L Charger)Find parts that fit my vehicle

Shielded Breathing. Designed with 2006-2010 3.5L Dodge Challenger Models compatibility, this Heat Shield Cold Air Intake draws cooler, denser charge air through a mandrel-bent pipe guarded by a powder-coated heat barrier, sharpening throttle response while adding a deep induction note that signals performance intent.

Construction and Appearance. The intake pipe is formed from lightweight aluminum alloy, TIG-welded for leak-free joints, then finished in a durable matte black coating that resists heat soak and corrosion. A matte red, high-flow synthetic filter anchors inside a precision-cut steel shield lined with rubber trim to isolate engine-bay heat. Stainless clamps, silicone couplers, and abrasion-resistant hose fittings complete the assembly, underscoring attention to long-term durability and a clean, understated aesthetic.

Installation. A direct-replacement layout reuses the factory mass-air sensor boss and mounting grommets, so the system bolts to existing studs without trimming body panels or rerouting wiring. Clear step-by-step instructions, labeled hardware, and pre-indexed couplers guide enthusiasts armed with basic hand tools to complete the upgrade in under an hour, while the adaptable design retains all factory vacuum lines and EVAP connections for emission compliance.

Application. This Heat Shield Cold Air Intake fits 2006-2010 3.5L Dodge Challenger Models. By channeling cooler air and reducing intake restriction, it frees up horsepower, sharpens mid-range torque, and lends the engine bay a purposeful look that pairs confidently with future performance mods.

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov