Pypes 1-5/8 in. Polished Shorty Headers (87-93 5.0L)

Customer Reviews (8) Write a Review

Overall Rating 4.0

out of 5 stars

Installation Time:Afternoon

• Performance Gain 4.333333 4.3
• Fit 2 2

• 2/5

  May 25, 2010

  need better product

  ok nothing against am. but these headers suck. they hit my steering rod so i had to take them off. what a waste of money.

  zach

  Helpful (4) Thanks for your input!
• 3/5

  October 23, 2010

  good looking parts but could be better

  These headers look nice and I like the thicker flanges on them, but as other reviers put the studs are incorrect and I have no clue why they sent them. Secondly the exhaust tubes are too big to accomidate the stock bolts but that is solved with a set of ARP header bolts. I also had to make one of the holes for #8 cylinder bigger to get the bolt to go in. But after these issues were adressed the install went smoothly. The only thing these need to be better is a little more R&D

  Henry

  Helpful (3) Thanks for your input!
• 5/5

  February 23, 2010

  poorley designed

  holes for the bolts are to close to the pipes to install factory bolts ,the stud they provide you with are to small in diameter ,and no nuts included ,just a big hassle

  fred

  Helpful (3) Thanks for your input!
• 5/5

  Installation Time: Afternoon

  April 14, 2013

  Pypes Headers for 92 G.T.

  The quality of this product is amazing. Especially for the price! The only issue I had was lining up the bolt pattern for the heads. Over all I strongly back this product. I will continue to give Pypes my buisness.

  Carter92

  Year: 1992 Submodel: GT Atascadero, CA, USA

  Helpful (1) Thanks for your input!

  • Performance Gain 4

    4

  • Fit 3

    3

  • Bang for your Buck 5

    5
• 3/5

  Installation Time: Less than 1 Hour

  September 27, 2011

  headers

  the only thing bad about the product is the header bolts wouldnt fit in the holes right without heating and bending the pipe.

  jackstone

  Year: 1992 Submodel: Other burlington, new jersey

  Helpful (1) Thanks for your input!

  • Performance Gain 4

    4

  • Fit 1

    1

  • Bang for your Buck 4

    4
• 5/5

  March 31, 2011

  Pypes for my 33 Hot Rod

  Pypes look and fit great, nice thick flanges, would like to see better hardware for connection at the collector end. Motor is in a FFR 33 Hot Rod so install was a piece of cake.

  Matthew Robichaud

  Year: 1989 Submodel: GT

  Helpful (1) Thanks for your input!
• 5/5

  August 20, 2010

  nice headers

  I was looking for a nice upgrade from stock. Product went on well. Good quality product for the price.

  Mike

  Helpful (1) Thanks for your input!
• 4/5

  Installation Time: Afternoon

  September 09, 2017

  Requires work for proper fit.

  Love the look and sound however using pretty small diameter bolts 6 or the 8 pipes had to be bent to clear enough space to install the bolts. If time wasnt a factor I probably would have switched to a different set.

  Jolly

  Year: 1988 Submodel: GT

  Helpful (0) Thanks for your input!

  • Performance Gain 5

    5

  • Fit 2

    2