Installation Time: Less than 1 Hour
May 15, 2013
Cervini Cobra R hood
Hood arrived well packaged, no damage. Hood was simple to install but needed lots of hinge adjustments which is to be expected, it required elongating the holes in the hood hinges because stock they have no adjustment.
After getting it centered hood latch adjusted using washers and longer bolts it fit as it should. There was extensive sanding needed to help with the front end edges of the hood to keep it from hitting the Saleen grille and tops of the headlights. This also was expected.
The surface of the hood was in very nice condition and required a minimal amount of block sanding for prep and no filling needed. IF I had a gripe it would be I wish the hood made use of the factory washer setup like some of their others, and two more items you need to put in weep holes to help drain water that gets in the heat vents in the rear, and due to the gelcoat you need to modify the holes drilled for the gaskets at the back end by the washer nozzles because they kind of filled in.
None of this takes away from this awesome hood, its clean, but still gives your car an aggressive look, very good quality.