- (1) Wheel
- (1) Center Cap
- Hardware included:
- None Required
$359.99 (each)FREE Shipping
Local Install Shops
Quoted installation from $125View 3 Shops
near 19355 (change)
Add TPMS Sensor Kit (recommended for 2015+)
Add TPMS Sync Tool
Forgestar F14 Monoblock Gunmetal Wheel - 18x10 (05-14 All, Excluding 13-14 GT500)
Hey Justin here with AmericanMuscle.com, and I’m checking out Forgestar’s F15 monoblock wheels, available in your choice of either matte black, gun metal, piano black, and silver, fitting all 2005 and newer Mustangs. At first glance you can see the design of the F14 Is more of a multispoke mesh wheel design, which has become extremely popular with the Mustang crowd as of late, which is course due to cars such as the RTR and the 2013 GT 500, both of which sport a variation of the mesh wheel design. These monoblock or one piece aluminum wheels go through an advanced process during production called rotary forging, this greatly improves the strength of the wheel, specifically the barrel, and generally reduces the weight of the wheel itself. The F14’s are offered in a wide variety of sizing options including an 18, 19, and 20 inch diameter, and in 9, 10, and 11 inch widths. Because there are a few different width options available, you can easily achieve that classic staggered look, by sticking a wider rear wheel and tire in the back versus the front, which in my opinion is the only way to roll. Chances are if you’re buying new wheels, you’re going to need new tires, we offer a pre built combinations, where we pair your F14’s up with some of the top tires on the market today, in sizes that are guaranteed to fit your car without rubbing, even if you’re lowered an inch or two. Of course you can also take advantage of our free mounting and balancing, free shipping and handling. Finally, all Forgestar wheels are backed by a lifetime structural warranty. When it does come time to install your new wheels just grab a floor jack and some basic hand tools. You’ll want to crack the lugs loose first on the stock wheels before getting the car in the air, after you do that, jack the car up and swap the 4 wheels and tires. Doesn’t get a lot easier than this, but since there is a little work involved, we’ll call it an hour from start to finish. So if you’re looking to take a break from the standard 5 spoke wheel and you want to go with a more modern multispoke mesh wheel design, then be sure to check out these quality lightweight aluminum wheels from Forgestar available right here at AmericanMuscle.com
Note: Priced per wheel.
Note: Requires either tuner lug nuts or 6-spline style lug nuts
Note: The stock lug nuts (13/16”) prove to be too large when used in conjunction with these wheels. Please take a look at the Lug Nut Ordering Options above for some compatible options.
Fitment: 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 Details
Mounting & Balancing: AmericanMuscle offers professional mounting and balancing on all wheels and tires when purchased together on the same order for an additional fee. This will allow you to swap out your old wheels for your new set when they arrive. We even offer Free Nitrogen tire fill.
What is TPMS? The Tire Pressure Monitoring System (TPMS for short) is a factory installed safety feature on all 2007 and newer Ford Mustangs that alerts you when your tire pressure drops to an unsafe limit.
How do I keep my TPMS feature? Aftermarket wheels do not come with TPMS sensors. However, if you select 'Add TPMS Sensor Kit' and your specific year range from the options listed above, we'll install the TPMS Sensors in your new wheels free of charge!
CA Residents: Warning: California's Proposition 65
Difficulty Level:Simple installation for anyone
|Placement:||Rear Only||Centercap Size:||na|
|Back Spacing:||7.1" (181mm)||Offset:||+42mm (1.7")|
|Bolt Pattern:||5x4.5" (5x114.3mm)||Weight:||20.1 lbs|
|Material:||Aluminum||Lip Size :||N/A|
|Best Tire :||275/40-18||Year/Model:||2005-2014 All, Excluding 2013-2014 GT500|
Does not fit 2013-2014 GT500
Will these fit over the Baer 6P on 14"Rotors I am looking for something that will fit my 67 Mustang. Currently I have the Saleen Gurney 19" wheels fitted with cooper 265 30 19 tires. I want to get a smaller diameter wheel to have more options for tire fitment. The Mustang has Baer 6P in the rear and 6S in the front. Both on 14" rotors. I want to know if these wheels will fit
Unfortunately we cannot guarantee fitment on custom setups. We can only guarantee fitment on the 2005 to 2014 Mustangs factory setup with the Forgestar F14 Monoblock Gunmetal Wheel - 18x10 (05-14 All).
Will these clear the Roush Trak Pak 6 Piston big brakes?
This Forgestar F14 Monoblock Gunmetal Wheel - 18x10 (05-14 All) should clear big brakes with no problem, but they will only fit the rear of your Mustang.
Installation Time:Full Day
Installation Time: Shop Install
Installation Cost: 0-$100
June 16, 2014
Excellent light weight option.
We run these F14's in 18x10 on all four corners. They are extremely light compared to the OEM and Ford Racing options. These weighed in on our scales at 20.4 lbs each which represents a 10 lbs savings at each wheel. The finish on the wheels is durable they have held up fantastic to all the abuse we've thrown at them. Make sure you get the smaller lug nuts as the openings on the F14 do not accommodate factory spec lugs. After testing our initial set and seeing the results, we purchased two additional sets. You can't go wrong with these wheels.
Bang for your Buck 5
Installation Time: Less than 1 Hour
February 28, 2014
Fits Baer Eradispeed +2 Brakes
I was looking for 18" wheels that will fit over my Baer Eradispeed +2 Rotors. These wheels fit great, look great, and are light.
Bang for your Buck 5
Installation Time: Afternoon
December 15, 2012
Lighter by far
I had been looking for lighter wheels for my 2011 MCA Edition Mustang. I did an enormous amount of research here at AM and at other sites. While American Muscle offers other wheels which are lighter than stock, these almost float out of the box. I had thought about the Matte black color as my paint is Kona Blue. The pictures of these wheels (gun metal) look much more to silver than they really are. When I saw them on sale, I felt I would put up with the color. I was super surprised when I unpacked them and they were a perfect match to the MCA wheel color. I could not be happier and the 18 inch wheels (9's up front & 10's on rear) clear my 14 inch Baer 2-pc rotors with plenty of space. If you are looking at these wheels, and can spring for the extra cost, my advice is to pull the trigger and do it.
Bang for your Buck 5