(approx) 1 Hour
Light to Moderate mechanical skill required.
Features, Description, Reviews, Q&A, Specs & Installation
Fitment: 1999 2000 2001 2002 Details
CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
April 02, 2019
Tunes suck Never ran right after
Tunes we're horrible. And way to difficult for such simpleHelpful (0)
November 17, 2017
WASTE OF MONEY
Well, I bought this back in June 2017, Lang with 24lb ingectors and a Bama custom chip, Ininstall the MAF along with the Chip and started getting a lot of misfires and the car would idle really rough and cut off, I found out by accident that by disconnecting the sensor out of the MAF the car would idle like it supposed to. I put the old MAF back on and had no more issues and no more misfires, I read other reviews similar to mine and now I know it was just me. Not buying anymore BBK itemsHelpful (7)
November 05, 2017
I installed this last summer along with ford racing 24# injectors. My mustang never idled correctly even with a dyno tune. Installed an oem sensor and issue was gone. My stang now idles perfectly. This item was a waste of time and moneyHelpful (5)
July 04, 2017
I had ordered the BBK 86mm Mass Air Meter for my Ford Performance 24lb injectors. I had installed the injectors and the Mass Air Meter with a new BAMA tune. When I had started the mustang it throw codes and kept cutting off with a rough idle. A week later I had taken the car to two different shops and they could not find the issue because I had thought it was a fuel injector or fuel pump issue but is was not. I had replaced the mass air meter with the original air meter and the issues were gone no more codes, rough idles or stalling. I would not get another mass air meter from BBK.Helpful (5)
April 18, 2017
Terrible does not work if you already have an aftermarket tune. Throws all kinds of codes. I put the stock one back on and it's fine. And since I put it on the car they won't allow me to exchange or return.Helpful (6)
April 14, 2017
Awesome and fast shipping and easy to install very helpful and nice will be ordering againHelpful (5)
August 21, 2016
It is a great product and it fits perfectly and my 24lb injectors gave my mustang more powerHelpful (7)
April 11, 2016
Check engine light came on after I put it on
I hope my reviews helps some people out because I just about had enough of bbk junk. I bought there 78mm throttle body just as I'm sure a lot of people did and the pedal sticks after trying to give it gas from a dead stop look on forums everyone is complaining about it. Then over the weekend I install there 86mm mass air flow sensor and the check engine light comes on right away, but they tell ya that it comes pre tuned and is a simple 10-15 hp. Well I'm here to tell you it's not. Apparently I'll have to buy a bama tuner or take it to get tuned or something because the car isn't exactly running right. So I hope this is useful to people my opinion save yourself the headache. STAY AWAY FROM BBK PRODUCTS. They have given me nothing but grey hairs!Helpful (6)
January 20, 2016
Great performance part
My old MAF was pegged out with my 24lb injectors and all my intake mods. This MAF really woke all my performance parts up. It's a great performance and cosmetic part. Highly recommendHelpful (6)
May 14, 2015
Mass air meter
You guys made this a great product already programmedHelpful (5)
Could this be re-calibrated for a different injector size (ie. 60lb)?
The BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors has the calibration for the injector size built into the MAF assembly and would not be able to be re-calibrated.
If this is already calibrated for 24lb injectors, why can't it be used on a 96-98 cobra since they already have factory 24lb injectors? Wouldn't a tune adjust any measurements needing to be adjusted since it's for 24lb injectors and the cobra is already equipped with 24lb injectors?
The BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors has the calibration for the injector size built into the MAF assembly, whereas the Cobra's have this part of the calibration built into the PCM. Swapping to a MAF calibrated for 24 lb/hr injectors in a GT would throw the calibration off in a Cobra, which is already set up for the 24lb/hr injectors in the PCM. We have not run the numbers for this used on a Cobra, but it would be essentially mean a final calibration over 24 lb/hr injectors on Cobra models.
Cannot find MAF for v6 with 24lb. Injectors. If the plug connection is modified would this work for the v6 or would it be to much air?
The BBK 86mm Mass Air Meter would not be properly calibrated for the V6. To adjust for injectors, the easiest route for your setup may be to adjust via a tune.
I have installed this MAF sensor with my new 24# injectors. My question is, can I also select 24# injectors in my canned SCT tune, or would it cause problems since this product is essentially skewing air flow reading to make the engine run fine wothout a tune. Thanks!
Since it is already calibrated, you will not need to select 24 lb injectors on your SCT tuner for the BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors.
Will this work with stock inje toes on a 99 gt? If not can it be tuned to work using my sct hand tuner?
Hello! The BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors is pre calibrated for 24lb injectors. It cannot be tuned for stock injectors.
The pinning for a 2003 GT is different from that of the 1999-2002 GT.
Correct, buying the pre-calibrated Mass Air Meter eliminates the need for re-calibration with a tuner.
Unfortunately you will not be able to use the BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors (99-02 GT) with 47lb injectors as it is already calibrated to work with 24lb injectors. You can stick with your stock MAF if you have 47lb injectors, you will need to have it retuned for the new size of the injectors.
The BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors (99-02 GT) would definitely be a good upgrade since you have a lot of modifications that have to do with airflow. It is not necessary though. Sometimes the car will begin to "peg" because of air restrictions. Though, Mass Air Meter would be a great add on to free up a good amount of power.
The BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors (99-02 GT) has fitment only for the 1999-2002 GT Mustangs. However, if the Bullitt Mustang has the same measurements as the BBK 86mm Mass Air Meter for Cold Air Intake and 24lb Injectors, it may work.
(approx) 1 Hour
Light to Moderate mechanical skill required.
What's in the Box
Not compatible with Cobra Mustangs