(approx) 1 Hour
Simple installation for anyone.
Features, Description, Reviews, Q&A, Specs & Installation
Technical Note. Will not fit with most strut tower braces.
Fitment: 2001 Details
CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
May 03, 2019
Cleanest CAI for the Bullitt
Clean intake, needs a bit of work to fit it, but well worth it!Helpful (0)
February 12, 2019
Great intake except for how low it is
Awesome intake does a great job in dry conditions! The intake and MAF sit pretty low in your Except for the fact that if you get caught in rain you run the chance of water getting in your intake and damaging your engine.Helpful (1)
June 05, 2018
Locked up my engine
Do not recommend this at all I hit some rain on my way home one night and hit some puddles and because where the filter is located on this it sucked water into my engine and completely locked up my engine and broke a rod so my engine is now done for.Helpful (5)
March 14, 2018
Sounds good and fits tight. I got a Bama tune also and the throttle response is greatHelpful (5)
March 05, 2018
I did a lot of looking around and comparing, This intake is just sweet. Looks good,fits well, and pulls in the air definitely going to look for more of the jlt products as they shoot them off the line. The time it took me to install is about and hour due to me trying to get the filter away from the tire because of the cars set up for drifting.Helpful (5)
June 30, 2017
my vehicle finally passed smog and the car feels and sounds better.Helpful (5)
January 15, 2016
Took me a little over an hour. It was difficult to get the intake in the wheel well to fit right. Not design fault, just was difficult. The customer submitted Intructions were more helpful than the supplied one. I do feel a increase in power. I also have a Bama tuner so together you can feel the Increase together. But it wasn't as much as I had anticipated. But still worth the money! Looks great too!Helpful (6)
November 01, 2014
wakes up your car
It took longer than expected. Also I had to take off the tire but well worth it. It is a great intake and looks awesome and turns your bullitt into a whole new carHelpful (6)
August 11, 2013
JLT I knows what they are doing!
JLT has made an exceptional cold air intake system for of the 2001 Bullitt! for people that are not mechanically inclined they might have some issues with the installation, but if you like working on cars it's absolutely excellent!Helpful (6)
April 08, 2013
This air intake is great, once you finally get it in. Installation was a bit of a pain, and I would strongly recommend that you get a tune after doing the intake. Even though they say that you don't need a tune you really do because your car is not going to run as good as it potentially could. I found that I had problems with decelerating and pushing the brake at the same time as the clutch the car would completely stall.Helpful (6)
Is hydrolocking really an issue? I daily drive my Bullitt, so it will see rain pretty frequently. Would puddle splash cause lock or would the filter have to be partially submerged?
No, you wouldn't have any issues with hydrolocking when using this intake. A lot of water would need to get into the engine before it would lock up.
Has anyone put this on their daily driver? I know the filter goes pretty low so I'm worried about it getting wet.
With the factory dust-pan and the fender-liners installed, the JLT Performance Next Generation Cold Air Intake will be isolated from moisture, including heavy rain and puddles. There are some intake pre-filters that are water resistant and would also add the benefit of filtering more air particles.
Since the MAF is inside the fender, does the MAF wiring need to be extended or otherwise modified? This is a Bullitt conversion on a 2001 Mustang GT Convertible. Is there any fitment problems using this JLT Bullitt CAI on a GT fascia? Thank you. Look forward your response!
With it being a Bullitt swap, you will want to make sure all of the other parts including the throttle body, and intake manifold have been swapped too. You may have to extend your MAF wiring just a tad, but you should be able to loosen up some clips to get some extra slack out of the wiring. As far as it fitting with the GT fascia that should not be an issue.
Any more gains over stock air intake? I have always heard that the factory bullitt is flowing pretty good. I have a k&n drop in filter i put on the factory intake. Is it really worth it to buy this?
Usually a 6to10 HP gain is realized from a cold air intake over the stock system, no matter what filter is in it.
(approx) 1 Hour
Simple installation for anyone.
What's in the Box
|Year/Model:||2001 Bullit||Filter Placement:||Inside Fender|
|Manufacture:||JLT Performance||Computer Tune Required:||No|
Will not fit with most strut tower braces